COMPANY HEADER
CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Terms
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 132000

Cone Part Number

 N/A EE132083

Design Units

 N/A Imperial

Cage Type

 N/A Stamped Steel
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 219000 lbf973000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 56700 lbf252000 N

Dimensions

d - Cone Bore

 N/A 8 in203.2 mm

B - Cone Width

 N/A 2.125 in53.975 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.16 in4.1 mm

da - Cone Frontface Backing Diameter

 N/A 8.58 in217.9 mm

db - Cone Backface Backing Diameter

 N/A 8.86 in225 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.17 in4.3 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.39 in9.9 mm
a - Effective Center Location4 N/A -0.24 in-6.1 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 32600 lbf145000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 126000 lbf559000 N

C0 - Static Radial Rating

 N/A 202000 lbf900000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 17500 lbf77800 N

Factors

K - Factor8 N/A 1.86

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 797.8

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 124.6
Cg - Geometry Factor9 N/A 0.117
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.