COMPANY HEADER
CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Terms
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Cone Part Number

 N/A EE157337

Design Units

 N/A Imperial

Cage Type

 N/A Pin-Type
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 1140000 lbf5060000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 295000 lbf1310000 N

Dimensions

d - Cone Bore

 N/A 33.7500 in857.250 mm

B - Cone Width

 N/A 4.3750 in111.125 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.750 in19.050 mm

da - Cone Frontface Backing Diameter

 N/A 35.2 in894 mm

db - Cone Backface Backing Diameter

 N/A 36.5 in927 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.31 in7.9 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.8 in20.3 mm
a - Effective Center Location4 N/A 4.43 in112.5 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 169000 lbf754000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 654000 lbf2910000 N

C0 - Static Radial Rating

 N/A 1710000 lbf7630000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 162000 lbf719000 N

Factors

K - Factor8 N/A 1.05

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 16100

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 1534.4
Cg - Geometry Factor9 N/A 0.377
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.