COMPANY HEADER
CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Terms
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 192000

Cone Part Number

 N/A EE192150

Design Units

 N/A Imperial

Cage Type

 N/A Stamped Steel
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 296000 lbf1320000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 76600 lbf341000 N

Dimensions

d - Cone Bore

 N/A 15.0000 in381.000 mm

B - Cone Width

 N/A 2.3125 in58.738 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.25 in6.4 mm

da - Cone Frontface Backing Diameter

 N/A 15.75 in400 mm

db - Cone Backface Backing Diameter

 N/A 16.14 in410 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.22 in5.6 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.65 in16.5 mm
a - Effective Center Location4 N/A 1.55 in39.4 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 44000 lbf196000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 170000 lbf755000 N

C0 - Static Radial Rating

 N/A 332000 lbf1480000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 40200 lbf179000 N

Factors

K - Factor8 N/A 1.1

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 2290

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 398
Cg - Geometry Factor9 N/A 0.195
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.