COMPANY HEADER
CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Terms
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 220000

Cone Part Number

 N/A EE221018

Design Units

 N/A Imperial

Cage Type

 N/A Stamped Steel
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 372000 lbf1650000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 96300 lbf429000 N

Dimensions

d - Cone Bore

 N/A 10.1875 in258.763 mm

B - Cone Width

 N/A 2.6563 in67.470 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.380 in9.700 mm

da - Cone Frontface Backing Diameter

 N/A 10.98 in279 mm

db - Cone Backface Backing Diameter

 N/A 11.61 in295 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.27 in6.9 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.53 in13.5 mm
a - Effective Center Location4 N/A 0.03 in0.8 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 55300 lbf246000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 213000 lbf949000 N

C0 - Static Radial Rating

 N/A 326000 lbf1450000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 37400 lbf166000 N

Factors

K - Factor8 N/A 1.48

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 1320.8

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 207.5
Cg - Geometry Factor9 N/A 0.150
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.