COMPANY HEADER
CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Terms
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 327000

Cone Part Number

 N/A EE327220

Design Units

 N/A Imperial

Cage Type

 N/A Pin-Type
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 1480000 lbf6610000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 385000 lbf1710000 N

Dimensions

d - Cone Bore

 N/A 22 in558.8 mm

B - Cone Width

 N/A 5.0937 in129.380 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.500 in12.700 mm

da - Cone Frontface Backing Diameter

 N/A 23.86 in606 mm

db - Cone Backface Backing Diameter

 N/A 24.57 in624 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.83 in21.08 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.87 in22.1 mm
a - Effective Center Location4 N/A 0.66 in16.8 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 221000 lbf984000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 853000 lbf3790000 N

C0 - Static Radial Rating

 N/A 1520000 lbf6760000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 154000 lbf687000 N

Factors

K - Factor8 N/A 1.43

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 7790.8

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 478.4
Cg - Geometry Factor9 N/A 0.272
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.