COMPANY HEADER
CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Terms
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 670000

Cone Part Number

 N/A EE671801

Design Units

 N/A Imperial

Cage Type

 N/A Pin-Type
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 1110000 lbf4920000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 287000 lbf1280000 N

Dimensions

d - Cone Bore

 N/A 18.0000 in457.200 mm

B - Cone Width

 N/A 4.5000 in114.300 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.380 in9.700 mm

da - Cone Frontface Backing Diameter

 N/A 19.33 in491 mm

db - Cone Backface Backing Diameter

 N/A 19.96 in507 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.54 in13.7 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.71 in18 mm
a - Effective Center Location4 N/A 0.21 in5.3 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 165000 lbf733000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 635000 lbf2830000 N

C0 - Static Radial Rating

 N/A 1100000 lbf4870000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 111000 lbf492000 N

Factors

K - Factor8 N/A 1.49

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 4970

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 343
Cg - Geometry Factor9 N/A 0.231
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.