COMPANY HEADER
CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Terms
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 743000

Cone Part Number

 N/A EE743240

Design Units

 N/A Imperial

Cage Type

 N/A Pin-Type
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 812000 lbf3610000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 211000 lbf937000 N

Dimensions

d - Cone Bore

 N/A 24.0000 in609.600 mm

B - Cone Width

 N/A 3.2500 in82.550 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.25 in6.4 mm

da - Cone Frontface Backing Diameter

 N/A 25.04 in636 mm

db - Cone Backface Backing Diameter

 N/A 25.39 in645 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.26 in6.6 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.33 in8.4 mm
a - Effective Center Location4 N/A 1.17 in29.7 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 121000 lbf538000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 467000 lbf2080000 N

C0 - Static Radial Rating

 N/A 912000 lbf4060000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 68200 lbf303000 N

Factors

K - Factor8 N/A 1.77

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 7714.7

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 995.4
Cg - Geometry Factor9 N/A 0.25
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.