COMPANY HEADER
CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Terms
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A H961600

Cone Part Number

 N/A H961649

Design Units

 N/A Imperial

Cage Type

 N/A Pin-Type
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 1240000 lbf5500000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 321000 lbf1430000 N

Dimensions

d - Cone Bore

 N/A 12.5000 in317.500 mm

B - Cone Width

 N/A 5.1875 in131.763 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.560 in14.200 mm

da - Cone Frontface Backing Diameter

 N/A 14.69 in373 mm

db - Cone Backface Backing Diameter

 N/A 16.14 in410 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.84 in21.3 mm

Aa - Cage-Cone Backface Clearance

 N/A 1.01 in25.7 mm
a - Effective Center Location4 N/A 2.38 in60.5 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 184000 lbf819000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 710000 lbf3160000 N

C0 - Static Radial Rating

 N/A 927000 lbf4130000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 295000 lbf1310000 N

Factors

K - Factor8 N/A 0.62

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 2500

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 149
Cg - Geometry Factor9 N/A 0.240
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.