COMPANY HEADER
CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Terms
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Cone Part Number

 N/A LL957049

Design Units

 N/A Imperial

Cage Type

 N/A Stamped Steel
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 52300 lbf233000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 13600 lbf60300 N

Dimensions

d - Cone Bore

 N/A 12.3125 in312.738 mm

B - Cone Width

 N/A 0.8125 in20.638 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.09 in2.290 mm

da - Cone Frontface Backing Diameter

 N/A 12.68 in322 mm

db - Cone Backface Backing Diameter

 N/A 12.8 in325 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.14 in3.6 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.09 in2.3 mm
a - Effective Center Location4 N/A 3.13 in79.5 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 7790 lbf34700 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 30000 lbf134000 N

C0 - Static Radial Rating

 N/A 86100 lbf383000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 11000 lbf48900 N

Factors

K - Factor8 N/A 0.71

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 990

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 808
Cg - Geometry Factor9 N/A 0.209
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.