COMPANY HEADER
CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Terms
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A LM763800

Cone Part Number

 N/A LM763848

Design Units

 N/A Imperial

Cage Type

 N/A Pin-Type
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 396000 lbf1760000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 103000 lbf457000 N

Dimensions

d - Cone Bore

 N/A 14.2500 in361.950 mm

B - Cone Width

 N/A 2.5 in63.5 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.13 in3.300 mm

da - Cone Frontface Backing Diameter

 N/A 14.96 in380 mm

db - Cone Backface Backing Diameter

 N/A 15.08 in383 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.22 in5.6 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.13 in3.3 mm
a - Effective Center Location4 N/A 1.19 in30.2 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 59000 lbf263000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 228000 lbf1010000 N

C0 - Static Radial Rating

 N/A 498000 lbf2210000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 47800 lbf213000 N

Factors

K - Factor8 N/A 1.24
Cg - Geometry Factor9 N/A 0.198
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.