COMPANY HEADER
CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Terms
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Design Units

 N/A Imperial
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 434000 lbf1930000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 112000 lbf500000 N

Dimensions

d - Cone Bore

 N/A 16.0000 in406.400 mm

B - Cone Width

 N/A 3.09375 in78.581 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.25 in6.4 mm

db - Cone Backface Backing Diameter

 N/A 17.36 in441.0 mm

Ab - Cage-Cone Frontface Clearance

 N/A -0.65 in-16.5 mm

Aa - Cage-Cone Backface Clearance

 N/A -0.23 in5.8 mm
a - Effective Center Location4 N/A 1.52 in38.9 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 64600 lbf287000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)6 N/A 55000 lbf245000 N

Factors

K - Factor7 N/A 1.17
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.