COMPANY HEADER
CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Terms
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 8500

Cone Part Number

 N/A NA8575SW

Design Units

 N/A Imperial

Cage Type

 N/A Stamped Steel

Dimensions

d - Cone Bore

 N/A 9.25 in234.95 mm

B - Cone Width

 N/A 2.3125 in58.738 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius1 N/A 0.25 in6.35 mm

da - Cone Frontface Backing Diameter

 N/A 0 in0 mm

db - Cone Backface Backing Diameter

 N/A 10.2 in259 mm

Ab - Cage-Cone Frontface Clearance

 N/A -0.05 in-1.3 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.31 in7.9 mm
a - Effective Center Location2 N/A 0.24 in6.1 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)3 N/A 30700 lbf137000 N
C1 - Dynamic Radial Rating (1 million revolutions)4 N/A 119000 lbf527000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)5 N/A 21400 lbf95200 N

Factors

K - Factor6 N/A 1.44

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 1050.5

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 172.4
  • 1 These maximum fillet radii will be cleared by the bearing corners.
  • 2 Negative value indicates effective center inside cone backface.
  • 3 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 4 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 6 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.