Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.

RELATED PRODUCTS

RELATED PRODUCTS

RELATED PRODUCTS

Unit of Measure

Key Dimensions

Cup Part Number

 N/A 29620-B

O.D. (D)

 N/A 4.4375 in112.713 mm

Outer Ring Width (C)

 N/A 0.7500 in19.050 mm
e Factor 1 N/A 0.49
K Factor 2 N/A 1.2
Y Factor 3 N/A 1.23

Other Dimensions

Weight

 N/A 0.9 Kg1.9 lb

Outer Ring Flange O.D.(D1)

 N/A 4.5900 in116.586 mm

Outer Ring Flange Width (C2)

 N/A 0.1563 in3.97 mm
Max Housing Fillet Radius4 N/A 0.130 in3.30 mm

Housing Backing Shoulder Dia. - Frontface (Da)

 N/A 4.35 in110.49 mm

Factors

G1 Factor

 N/A 63.9

G2 Factor

 N/A 17.1
Geometry Factor (Cg)5 N/A 0.117
  • 1 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 2 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 These maximum fillet radii will be cleared by the bearing corners.
  • 5 Geometry constant for Lubrication Life Adjustment Factor a3l.