Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
RELATED PRODUCTS
RELATED PRODUCTS
RELATED PRODUCTS
RELATED PRODUCTS
Unit of Measure
Key Dimensions
Cup Part Number |
N/A 532-B |
O.D. (D) |
N/A 4.3750 in111.125 mm |
Outer Ring Width (C) |
N/A 1.1875 in30.163 mm |
| e Factor 1 | N/A 0.3 |
| K Factor 2 | N/A 1.97 |
| Y Factor 3 | N/A 2.02 |
- 1 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
- 2 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
- 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
- 4 These maximum fillet radii will be cleared by the bearing corners.
- 5 Geometry constant for Lubrication Life Adjustment Factor a3l.