Menu
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 07000

Cone Part Number

 07100

Cup Part Number

 07204

Design Unit

 Inch

Cage Material

 Stamped Steel

Related Assembly Number(s)

 07100-90048

Dimensions

d - Bore

 1 in25.400 mm

D - Cup Outer Diameter

 2.047 in51.994 mm

B - Cone Width

 0.5614 in14.260 mm

C - Cup Width

 0.5000 in12.700 mm

T - Bearing Width

 0.5910 in15.011 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius1 0.040 in1 mm
r - Cup Backface "To Clear" Radius2 0.050 in1.27 mm

da - Cone Frontface Backing Diameter

 1.16 in29.5 mm

db - Cone Backface Backing Diameter

 1.2 in30.5 mm

Da - Cup Frontface Backing Diameter

 1.91 in48.51 mm

Db - Cup Backface Backing Diameter

 1.77 in44.96 mm

Ab - Cage-Cone Frontface Clearance

 0.08 in2 mm

Aa - Cage-Cone Backface Clearance

 0 in0 mm
a - Effective Center Location3 -0.11 in-2.8 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)4 1700 lbf7550 N
C1 - Dynamic Radial Rating (1 million revolutions)5 6540 lbf29100 N

C0 - Static Radial Rating

 6650 lbf29600 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)6 1170 lbf5190 N

Factors

K - Factor7 1.45
e - ISO Factor8 0.4
Y - ISO Factor9 1.49

G1 - Heat Generation Factor (Roller-Raceway)

 7.6

G2 - Heat Generation Factor (Rib-Roller End)

 7.1
Cg - Geometry Factor10 0.0509
  • 1 These maximum fillet radii will be cleared by the bearing corners.
  • 2 These maximum fillet radii will be cleared by the bearing corners.
  • 3 Negative value indicates effective center inside cone backface.
  • 4 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 5 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 10 Geometry constant for Lubrication Life Adjustment Factor a3l.