Menu
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 19000

Cone Part Number

 19138

Cup Part Number

 19262

Design Unit

 Inch

Cage Material

 Stamped Steel

Dimensions

d - Bore

 1.3770 in34.976 mm

D - Cup Outer Diameter

 2.6250 in66.675 mm

B - Cone Width

 0.6504 in16.520 mm

C - Cup Width

 0.4688 in11.908 mm

T - Bearing Width

 0.6250 in15.875 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius1 0.06 in1.5 mm
r - Cup Backface "To Clear" Radius2 0.030 in0.76 mm

da - Cone Frontface Backing Diameter

 1.59 in40.5 mm

db - Cone Backface Backing Diameter

 1.67 in42.5 mm

Da - Cup Frontface Backing Diameter

 2.56 in65.00 mm

Db - Cup Backface Backing Diameter

 2.40 in60.96 mm

Ab - Cage-Cone Frontface Clearance

 0.09 in2.3 mm

Aa - Cage-Cone Backface Clearance

 0.03 in0.8 mm
a - Effective Center Location3 -0.06 in-1.5 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)4 2960 lbf13100 N
C1 - Dynamic Radial Rating (1 million revolutions)5 11400 lbf50700 N

C0 - Static Radial Rating

 13000 lbf57800 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)6 2250 lbf10000 N

Factors

K - Factor7 1.31
e - ISO Factor8 0.44
Y - ISO Factor9 1.35

G1 - Heat Generation Factor (Roller-Raceway)

 17.5

G2 - Heat Generation Factor (Rib-Roller End)

 11.5
Cg - Geometry Factor10 0.0694
  • 1 These maximum fillet radii will be cleared by the bearing corners.
  • 2 These maximum fillet radii will be cleared by the bearing corners.
  • 3 Negative value indicates effective center inside cone backface.
  • 4 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 5 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 10 Geometry constant for Lubrication Life Adjustment Factor a3l.