Menu
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 3400

Cone Part Number

 3477

Cup Part Number

 3420

Design Unit

 Inch

Cage Material

 Stamped Steel

Dimensions

d - Bore

 1 5/16 in33.338 mm

D - Cup Outer Diameter

 3.1250 in79.375 mm

B - Cone Width

 1.1721 in29.771 mm

C - Cup Width

 0.9375 in23.813 mm

T - Bearing Width

 1.1563 in29.370 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius1 0.14 in3.600 mm
r - Cup Backface "To Clear" Radius2 0.130 in3.30 mm

da - Cone Frontface Backing Diameter

 1.67 in42.5 mm

db - Cone Backface Backing Diameter

 1.93 in49 mm

Da - Cup Frontface Backing Diameter

 2.94 in74.68 mm

Db - Cup Backface Backing Diameter

 2.64 in67.06 mm

Ab - Cage-Cone Frontface Clearance

 0.05 in1.3 mm

Aa - Cage-Cone Backface Clearance

 0.04 in1 mm
a - Effective Center Location3 -0.34 in-8.6 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)4 6100 lbf27100 N
C1 - Dynamic Radial Rating (1 million revolutions)5 23500 lbf105000 N

C0 - Static Radial Rating

 26800 lbf119000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)6 3820 lbf17000 N

Factors

K - Factor7 1.6
e - ISO Factor8 0.37
Y - ISO Factor9 1.64

G1 - Heat Generation Factor (Roller-Raceway)

 29.9

G2 - Heat Generation Factor (Rib-Roller End)

 11.2
Cg - Geometry Factor10 0.0781
  • 1 These maximum fillet radii will be cleared by the bearing corners.
  • 2 These maximum fillet radii will be cleared by the bearing corners.
  • 3 Negative value indicates effective center inside cone backface.
  • 4 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 5 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 10 Geometry constant for Lubrication Life Adjustment Factor a3l.