Menu
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 435

Cone Part Number

 441

Cup Part Number

 432

Design Unit

 Inch

Cage Material

 Stamped Steel

Dimensions

d - Bore

 1.3780 in35.001 mm

D - Cup Outer Diameter

 3.7500 in95.250 mm

B - Cone Width

 1.1772 in29.901 mm

C - Cup Width

 0.8750 in22.225 mm

T - Bearing Width

 1.0940 in27.788 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius1 0.14 in3.600 mm
r - Cup Backface "To Clear" Radius2 0.090 in2.29 mm

da - Cone Frontface Backing Diameter

 1.71 in43.5 mm

db - Cone Backface Backing Diameter

 1.97 in50 mm

Da - Cup Frontface Backing Diameter

 3.46 in87.88 mm

Db - Cup Backface Backing Diameter

 3.27 in83.06 mm

Ab - Cage-Cone Frontface Clearance

 0.05 in1.3 mm

Aa - Cage-Cone Backface Clearance

 0.04 in1 mm
a - Effective Center Location3 -0.36 in-9.1 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)4 7400 lbf32900 N
C1 - Dynamic Radial Rating (1 million revolutions)5 28500 lbf127000 N

C0 - Static Radial Rating

 32400 lbf144000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)6 3600 lbf16000 N

Factors

K - Factor7 2.05
e - ISO Factor8 0.28
Y - ISO Factor9 2.11

G1 - Heat Generation Factor (Roller-Raceway)

 42.5

G2 - Heat Generation Factor (Rib-Roller End)

 11.3
Cg - Geometry Factor10 0.0805
  • 1 These maximum fillet radii will be cleared by the bearing corners.
  • 2 These maximum fillet radii will be cleared by the bearing corners.
  • 3 Negative value indicates effective center inside cone backface.
  • 4 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 5 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 10 Geometry constant for Lubrication Life Adjustment Factor a3l.