TDI bearings have a one-piece double inner race and two single outer races and are typically supplied complete with an outer race spacer as a pre-set assembly. The bearing can be used at fixed positions on rotation shaft applications. For rotating housing application it can be used to float on the stationary shaft.
RELATED PRODUCTS
RELATED PRODUCTS
Unit of Measure
Key Dimensions
Cone Part Number |
N/A H239649D |
Bore (d) |
N/A 7.3750 in187.325 mm |
| Dynamic Radial Load Rating - 1M Revs (C1) 1 | N/A 236000 lbf1050000 N |
| Dynamic Radial Load Rating - 90M Revs (C90) 2 | N/A 61100 lbf272000 N |
| Dynamic Radial Load Rating 2-Row - 90M Revs (C90-2row) 3 | N/A 106000 lbf473000 N |
| K Factor 4 | N/A 1.83 |
Other Dimensions
Weight |
N/A 51.1 Kg112.6 lb |
Inner Ring Width (B) |
N/A 6.3750 in161.925 mm |
| Max Shaft Fillet Radius5 | N/A 0.13 in3.300 mm |
Shaft Backing Shoulder Dia. - Frontface (da) |
N/A 8.23 in209 mm |
Cage Location rel. to FF (Ab) |
N/A 0.14 in3.6 mm |
- 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
- 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
- 3 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
- 4 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
- 5 These maximum fillet radii will be cleared by the bearing corners.
- 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
- 7 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
- 8 Geometry constant for Lubrication Life Adjustment Factor a3l.