TDI bearings have a one-piece double inner race and two single outer races and are typically supplied complete with an outer race spacer as a pre-set assembly. The bearing can be used at fixed positions on rotation shaft applications. For rotating housing application it can be used to float on the stationary shaft.
RELATED PRODUCTS
Unit of Measure
Key Dimensions
Cone Part Number |
N/A L540049D |
Bore (d) |
N/A 7.7500 in196.850 mm |
| Dynamic Radial Load Rating - 1M Revs (C1) 1 | N/A 47400 lbf211000 N |
| Dynamic Radial Load Rating - 90M Revs (C90) 2 | N/A 12300 lbf54700 N |
| Dynamic Radial Load Rating 2-Row - 90M Revs (C90-2row) 3 | N/A 21400 lbf95200 N |
| K Factor 4 | N/A 1.47 |
Other Dimensions
Weight |
N/A 6.5 Kg14.4 lb |
Inner Ring Width (B) |
N/A 2.0626 in52.390 mm |
| Max Shaft Fillet Radius5 | N/A 0.06 in1.5 mm |
Shaft Backing Shoulder Dia. - Frontface (da) |
N/A 8.15 in207 mm |
Cage Location rel. to FF (Ab) |
N/A 0.1 in2.5 mm |
- 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
- 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
- 3 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
- 4 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
- 5 These maximum fillet radii will be cleared by the bearing corners.
- 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
- 7 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
- 8 Geometry constant for Lubrication Life Adjustment Factor a3l.