3D CAD and 2D Drawings

Find and download 3D CAD and 2D drawings for key Timken products.

This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Cone Part Number

N/A 11590A

Design Units

N/A Imperial

Cage Type

N/A Stamped Steel
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 6810 lbf30300 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 1770 lbf7860 N

Dimensions

d - Bore

N/A 0.6250 in15.875 mm

B - Cone Width

N/A 0.5625 in14.288 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.06 in1.520 mm

da - Cone Frontface Backing Diameter

N/A 0.91 in23 mm

db - Cone Backface Backing Diameter

N/A 1.18 in30 mm

Ab - Cage-Cone Frontface Clearance

N/A 0.05 in1.3 mm

Aa - Cage-Cone Backface Clearance

N/A 0.04 in1 mm
a - Effective Center Location4 N/A -0.05 in-1.3 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 1010 lbf4510 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 3910 lbf17400 N

C0 - Static Radial Rating

N/A 3920 lbf17400 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 1220 lbf5430 N

Factors

K - Factor8 N/A 0.83

G1 - Heat Generation Factor (Roller-Raceway)

N/A 3.4

G2 - Heat Generation Factor (Rib-Roller End)

N/A 4.6
Cg - Geometry Factor9 N/A 0.0465
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.
By clicking Submit, you consent to the personal information you provide being accessible by Timken personnel, who may be located outside your home country, as described in our Privacy Notice.