This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.

RELATED PRODUCTS

RELATED PRODUCTS

Unit of Measure

Key Dimensions

Cone Part Number

 N/A 943

Bore (d)

 N/A 3.8750 in98.425 mm

Inner Ring Width (B)

 N/A 2.6250 in66.675 mm
Dynamic Radial Load Rating - 1M Revs (C1) 1 N/A 129000 lbf572000 N
Dynamic Radial Load Rating - 90M Revs (C90) 2 N/A 33300 lbf148000 N
K Factor 3 N/A 1.79

Other Dimensions

Weight

 N/A 50.69 lb22.995 Kg
Effective Center Location4 N/A -0.78 in-19.8 mm
Max Shaft Fillet Radius5 N/A 0.14 in3.600 mm

Shaft Backing Shoulder Diameter - Frontface (da)

 N/A 4.49 in114 mm

Shaft Backing Shoulder Diameter - Backface (db)

 N/A 4.72 in120 mm

Cage Location rel. to BF (Aa)

 N/A 0.23 in5.8 mm

Cage Location rel. to FF (Ab)

 N/A 0.09 in2.3 mm

Ratings

Dynamic Axial Rating - 90M Revs (Ca90)6 N/A 18600 lbf82700 N

Static Radial Load Rating (CO)

 N/A 177000 lbf786000 N

Factors

G1 Factor

 N/A 338.6

G2 Factor

 N/A 39.8
Geometry Factor (Cg)7 N/A 0.115
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 These maximum fillet radii will be cleared by the bearing corners.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 Geometry constant for Lubrication Life Adjustment Factor a3l.