This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Key Dimensions

Cone Part Number

 N/A H225148

Bore (d)

 N/A 4.6250 in117.475 mm

Inner Ring Width (B)

 N/A 2.7500 in69.850 mm
Dynamic Radial Load Rating - 1M Revs (C1) 1 N/A 116000 lbf518000 N
Dynamic Radial Load Rating - 90M Revs (C90) 2 N/A 30200 lbf134000 N
K Factor 3 N/A 1.73

Other Dimensions

Weight

 N/A 20.5 lb9.300 Kg
Effective Center Location4 N/A -0.7 in-17.8 mm
Max Shaft Fillet Radius5 N/A 0.310 in7.870 mm

Shaft Backing Shoulder Diameter - Frontface (da)

 N/A 5.32 in135.3 mm

Shaft Backing Shoulder Diameter - Backface (db)

 N/A 5.79 in147 mm

Cage Location rel. to BF (Aa)

 N/A 0.17 in4.3 mm

Cage Location rel. to FF (Ab)

 N/A 0.04 in1 mm

Ratings

Dynamic Axial Rating - 90M Revs (Ca90)6 N/A 17400 lbf77400 N

Static Radial Load Rating (CO)

 N/A 168000 lbf747000 N

Factors

G1 Factor

 N/A 342.2

G2 Factor

 N/A 54.4
Geometry Factor (Cg)7 N/A 0.117
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 These maximum fillet radii will be cleared by the bearing corners.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 Geometry constant for Lubrication Life Adjustment Factor a3l.