This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.

RELATED PRODUCTS

RELATED PRODUCTS

RELATED PRODUCTS

Unit of Measure

Key Dimensions

Cone Part Number

 N/A HH228340

Bore (d)

 N/A 4.7500 in120.650 mm

Inner Ring Width (B)

 N/A 3.2500 in82.550 mm
Dynamic Radial Load Rating - 1M Revs (C1) 1 N/A 205000 lbf910000 N
Dynamic Radial Load Rating - 90M Revs (C90) 2 N/A 53000 lbf236000 N
K Factor 3 N/A 1.82

Other Dimensions

Effective Center Location4 N/A -0.92 in-23.4 mm
Max Shaft Fillet Radius5 N/A 0.380 in9.700 mm

Shaft Backing Shoulder Diameter - Frontface (da)

 N/A 5.59 in142 mm

Shaft Backing Shoulder Diameter - Backface (db)

 N/A 6.22 in158 mm

Cage Location rel. to BF (Aa)

 N/A 0.25 in6.3 mm

Cage Location rel. to FF (Ab)

 N/A 0.05 in1.3 mm

Ratings

Dynamic Axial Rating - 90M Revs (Ca90)6 N/A 29200 lbf130000 N

Static Radial Load Rating (CO)

 N/A 279000 lbf1240000 N

Factors

G1 Factor

 N/A 530

G2 Factor

 N/A 44.8
Geometry Factor (Cg)7 N/A 0.133
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 These maximum fillet radii will be cleared by the bearing corners.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 Geometry constant for Lubrication Life Adjustment Factor a3l.