This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Key Dimensions

UPC

 N/A 0053893179476

Bore (d)

 N/A 1 1/2 in38.1 mm

Inner Ring Width (B)

 N/A 0.9062 in23.0175 mm
Dynamic Radial Load Rating - 90M Revs (C90) 1 N/A 3920 lbf17400 N
e Factor 2 N/A 0.4
K Factor 3 N/A 1.45

Other Dimensions

Effective Center Location4 N/A -0.12 in-3 mm
Max Shaft Fillet Radius5 N/A 0.080 in2.0 mm

Shaft Backing Shoulder Diameter - Backface (db)

 N/A 1.83 in46.5 mm

Cage Location rel. to BF (Aa)

 N/A 0.09062 in2.30175 mm

Cage Location rel. to FF (Ab)

 N/A -0.04531 in-1.150875 mm

Ratings

Dynamic Axial Rating - 90M Revs (Ca90)6 N/A 2700 lbf12000 N
  • 1 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 2 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 These maximum fillet radii will be cleared by the bearing corners.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.