The Timken Company
The Timken Company
4500 Mt Pleasant St. NW
N. Canton, OH 44720
Phone: (234) 262-3000
E-Mail: CustomerCAD@timken.com • Web site: www.timken.com
Print Back
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.

RELATED PRODUCTS

RELATED PRODUCTS

RELATED PRODUCTS

RELATED PRODUCTS

RELATED PRODUCTS

Unit of Measure

Key Dimensions

Cone Part Number

 N/A 05062

Bore (d)

 N/A 5/8 in15.875 mm

Inner Ring Width (B)

 N/A 0.5662 in14.381 mm
Dynamic Radial Load Rating - 1M Revs (C1) 1 N/A 6010 lbf26700 N
Dynamic Radial Load Rating - 90M Revs (C90) 2 N/A 1560 lbf6930 N
K Factor 3 N/A 1.64

Other Dimensions

Weight

 N/A 0.62 lb0.281 Kg
Effective Center Location4 N/A -0.16 in-4.1 mm
Max Shaft Fillet Radius5 N/A 0.06 in1.5 mm

Shaft Backing Shoulder Diameter - Frontface (da)

 N/A 0.83 in21 mm

Shaft Backing Shoulder Diameter - Backface (db)

 N/A 0.93 in23.5 mm

Cage Location rel. to BF (Aa)

 N/A -0.01 in-0.3 mm

Cage Location rel. to FF (Ab)

 N/A 0.07 in1.8 mm

Ratings

Dynamic Axial Rating - 90M Revs (Ca90)6 N/A 952 lbf4230 N

Static Radial Load Rating (CO)

 N/A 5720 lbf25400 N

Factors

G1 Factor

 N/A 5.8

G2 Factor

 N/A 5.5
Geometry Factor (Cg)7 N/A 0.0448
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 These maximum fillet radii will be cleared by the bearing corners.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 Geometry constant for Lubrication Life Adjustment Factor a3l.