The Timken Company
The Timken Company
4500 Mt Pleasant St. NW
N. Canton, OH 44720
Phone: (234) 262-3000
E-Mail: CustomerCAD@timken.com • Web site: www.timken.com
Print Back
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.

RELATED PRODUCTS

RELATED PRODUCTS

RELATED PRODUCTS

RELATED PRODUCTS

Unit of Measure

Key Dimensions

Cone Part Number

 N/A 99575

Bore (d)

 N/A 5.7500 in146.050 mm

Inner Ring Width (B)

 N/A 2.6250 in66.675 mm
Dynamic Radial Load Rating - 1M Revs (C1) 1 N/A 148000 lbf660000 N
Dynamic Radial Load Rating - 90M Revs (C90) 2 N/A 38500 lbf171000 N
K Factor 3 N/A 1.43

Other Dimensions

Weight

 N/A 62.91 lb28.534 Kg
Effective Center Location4 N/A -0.48 in-12.2 mm
Max Shaft Fillet Radius5 N/A 0.280 in7.100 mm

Shaft Backing Shoulder Diameter - Frontface (da)

 N/A 6.69 in170 mm

Shaft Backing Shoulder Diameter - Backface (db)

 N/A 7.01 in178 mm

Cage Location rel. to BF (Aa)

 N/A 0.34 in8.6 mm

Cage Location rel. to FF (Ab)

 N/A 0.19 in4.8 mm

Ratings

Dynamic Axial Rating - 90M Revs (Ca90)6 N/A 26800 lbf119000 N

Static Radial Load Rating (CO)

 N/A 231000 lbf1030000 N

Factors

G1 Factor

 N/A 555.5

G2 Factor

 N/A 73.5
Geometry Factor (Cg)7 N/A 0.146
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 These maximum fillet radii will be cleared by the bearing corners.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 Geometry constant for Lubrication Life Adjustment Factor a3l.