The Timken Company
The Timken Company
4500 Mt Pleasant St. NW
N. Canton, OH 44720
Phone: (234) 262-3000
E-Mail: CustomerCAD@timken.com • Web site: www.timken.com
Print Back
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Key Dimensions

Cone Part Number

 N/A EE122080

Bore (d)

 N/A 8 in203.2 mm

Inner Ring Width (B)

 N/A 2.6250 in66.675 mm
Dynamic Radial Load Rating - 1M Revs (C1) 1 N/A 171000 lbf761000 N
Dynamic Radial Load Rating - 90M Revs (C90) 2 N/A 44400 lbf197000 N
e Factor 3 N/A 0.3
K Factor 4 N/A 1.97
Y Factor 5 N/A 2.03

Other Dimensions

Weight

 N/A 40.10 lb18.20 Kg
Effective Center Location6 N/A -0.44 in-11.2 mm
Max Shaft Fillet Radius7 N/A 0.170 in4.320 mm

Shaft Backing Shoulder Diameter - Frontface (da)

 N/A 8.58 in218 mm

Shaft Backing Shoulder Diameter - Backface (db)

 N/A 8.86 in225 mm

Cage Location rel. to BF (Aa)

 N/A 0.25 in6.4 mm

Cage Location rel. to FF (Ab)

 N/A 0.11 in2.8 mm

Ratings

Dynamic Axial Rating - 90M Revs (Ca90)8 N/A 22500 lbf100000 N

Static Radial Load Rating (CO)

 N/A 292000 lbf1300000 N

Factors

G1 Factor

 N/A 951.5

G2 Factor

 N/A 141.7
Geometry Factor (Cg)9 N/A 0.123
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 5 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 6 Negative value indicates effective center inside cone backface.
  • 7 These maximum fillet radii will be cleared by the bearing corners.
  • 8 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.