TNA bearings are similar to the TDO, but the inner race narrow faces are extended to abut and eliminate the need for a separate inner race spacer. Supplied with an in-built clearance to give a standard setting range, these bearings provide a solution for many fixed or floating bearing applications where simplicity of assembly is required.

Design Attributes:
  • Double cup and two single cones
  • Internal bearing clearance controlled by extending the front faces of the cones so they contact each other
  • SW variation features chamfers in the bores at the front faces of the two single cones to form a lubrication groove
  • SE variation features a backface rib design to accommodate radial lip seals or stamped closure
Unit of Measure

Key Dimensions

Cone Part Number

 N/A NA15117SW

Cup Part Number

 N/A 15251D

Bore (d)

 N/A 1.1813 in30.005 mm

O.D. (D)

 N/A 2.5000 in63.500 mm

Width (T)

 N/A 2 in50.8 mm
Dynamic Radial Load Rating - 1M Revs (C1)1 N/A 19800 lbf88000 N
Dynamic Radial Load Rating - 90M Revs (C90) 2 N/A 2940 lbf13100 N
Dynamic Radial Load Rating 2-Row - 90M Revs (C90-2row)3 N/A 5130 lbf22800 N
e Factor 4 N/A 0.35
K Factor 5 N/A 1.67

Other Dimensions

Weight

 N/A 1.605 lb0.73 Kg

Outer Ring Width (C)

 N/A 1.4375 in36.513 mm
Max Shaft Fillet Radius6 N/A 0.030 in0.8 mm
Max Housing Fillet Radius7 N/A 0.03 in0.8 mm

Shaft Backing Shoulder Dia. - Backface (db)

 N/A 1.4 in35.5 mm

Housing Backing Shoulder Dia. - Frontface (Da)

 N/A 2.34 in58.93 mm

Ratings

Dynamic Axial Rating - 90M Revs (Ca90)8 N/A 1770 lbf7860 N

Factors

Y1 Factor 9 N/A 1.93
Y2 Factor 10 N/A 2.87
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 3 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 4 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 5 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 6 These maximum fillet radii will be cleared by the bearing corners.
  • 7 These maximum fillet radii will be cleared by the bearing corners.
  • 8 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 9 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 10 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.